Configuring LNB Settings on Your Satellite Receiver
The LNB settings menu looks technical, but for most viewers it has one right answer. Here is what each option means, and what you should set.
LNB Power: On
The receiver powers the LNB over the coax. If this is off, you get no signal at all. Leave it on.
LNB Type: Universal
For a modern European LNB, choose “Universal”. This sets the two local oscillators (9.75 / 10.60 GHz) automatically. If it is set to “standard” or “single”, the high band will not tune.
13/18 V: Auto
Leave on auto. The receiver switches voltage to select polarity.
22 kHz Tone: Auto
Leave on auto. The receiver adds the tone to select the high band.
DiSEqC Port
If you have a DiSEqC switch, set each satellite to the matching physical port (1, 2, 3 or 4). If you have one LNB directly, leave it off.
Transponder List
Usually you do not edit transponders manually. A scan fills them in. Only edit them if you are adding a specific known frequency.
When to Change Anything
Leave the defaults alone unless you have a specific reason. The default “universal + auto” works on 99% of European setups.
If You Suspect the Settings
Set LNB type to universal, power on, everything auto, and rescan. This clears most mysterious “missing channel” problems.
LNB settings are one of those menus you set once and never touch. Universal + auto is the answer.
